信息类型：供应

IP113M / IP113F Managed 10/100Base-TX / FX Media Converter

General Description :
IP113M can be a 10/100BASE-TX to 100BASE-FX converter or a 100BASE-FX to 100BASE-FX repeater with an SMI port for management. It consists of a 2-port switch controller, a fast Ethernet transceiver and a PHY for 100BASE-FX. The transceivers in IP113M are designed in DSP approach with advance 0.25um technology; this results in high noise immunity and robust performance.
Besides store and forward mode, IP113M supports modified cut through mode and pure converter mode for low latency data forwarding. IP113M can forward packets up to 1600 bytes to meet requirement of extra long packets.
IP113M supports remote management function. Besides remote monitor and loop back test function defined in TS-1000, IP113M supports remote access functions. Local IP113M can access the MII register of remote IP113M by programming local IP113M's MII registers via SMI. IP113M implements the management function using the maintenance frame defined in TS-1000.
IP113M supports IEEE802.3x, collision base backpressure, and various LED functions, etc. These functions can be configured to fit the different requirements by feeding operation parameters via EEPROM interface or pull up/down resistors on specified pins.
Feature :
A 10/100BASE-TX/100BASE-FX converter with a SMI port for management
Built in a 10/100BASE-TX transceiver
Built in a PHY for 100BASE-FX
Built in a 2-port switch
- Pass all packets without address and CRC check (optional)
- Supports modified cut-through frame forwarding for low latency
- Supports pure converter mode data forwarding for extreme low latency
- Supports flow control for full and half duplex operation
- Bandwidth control
- Forward 1600 bytes packet for management
- Optional forward fragments
Built in 128Kb RAM for data buffer
Supports 3.3v I/O tolerance SMI (MDC, MDIO) and MII registers for management
- Configure local and remote IP113M through local SMI
- Monitor local and remote IP113M through local SMI
- Configure/monitor TP port support (auto-negotiation or force 10M/100M, full/half)
- Configure/monitor flow control, bandwidth
- Supports loop back test (In-band or out-band, auto or program)
- The maintenance frame is compatible to TS-1000 standard (the Telecommunication Technology Committee, TTC)
Supports Statistic Counters
Supports auto MDI-MDIX function
Supports link fault pass through function
Supports far end fault function
LED display for link/activity, full/half, 10/100
Built in a watchdog timer to monitor internal switch error
Supports EEPROM Configuration
0.25um CMOS technology
Single 2.5v power supply 48-pin LQFP package